![]() To recalculate a previously measured area or volume with a newly set unit of measure, just click Recalculate. If the Store Scale in Page option isn’t available, scroll down to the Options section of the Measurements tab and select Use Embedded Scale. To keep this configuration when the PDF is saved, select Store Scale in Page.Select a unit of measure for Area Unit and Volume Unit.They will exist separately from each other, and the default unit of measurement will be used for linear measurements. You can set independent units of measurement for Area and Volume. Scales, units of measurement and Store Scale in Page are set on a per-page basis. The unit of measurement used when calibrating the drawing is now the default for all measurements on that page. In the Calibration dialog box, enter the distance that the line between these two points represents on the drawing and select the units in which measurements are to be reported.When the second point is selected, the Calibration dialog box opens. ![]() ![]() ![]() Hold down the Shift key to snap the two points horizontally, vertically or diagonally. Click the first point of the known length, then click a second point to finish the line.If a dialog box with instructions appears, click OK.From the Scale section of the Measurements tab, click Calibrate.From the Command bar, go to Measure > Calibrate.Open the Calibrate tool using one of the following methods:.How to Use Different Measurement Units on a PDF Calibrate the Pageīefore you get started, make sure the page is properly calibrated:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |